Why No One Cares About Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot’s 308 might be somewhat old-fashioned, but it is still eye-catching. It’s not the most luxurious vehicle in its class, but it’s an enjoyable and relaxing driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 307 key fob programming 308 key fobs. The following tips will help whether the problem is ongoing or intermittent.

Water Damage

If you accidentally drop your key fob in a puddle or it gets wet while kayaking, canoeing, rafting, or canyoning the fob is more likely to be damaged by water. The best way to stop this from happening is to keep it in a dry bag whenever you’re outside or performing activities in which the fob may be exposed to excessive amounts of water.

It is also important to ensure that the fob is completely dry before opening it up and re-using it. If you notice any odors coming from the fob, like an industrial-like liquid smell or windshield washer fluid, this is another sign that it’s been submerged in water.

A wet circuit can cause the battery’s energy to drain or even explode. If you’re able to fish your key fob 308 out of whatever body of water it got stuck in then flip the button side down and shake it out as much water as possible before opening the case. Remove the battery, then clean the circuit board with a cotton swab that has been submerged in 90 percent alcohol.

Other reasons your Peugeot 308 remote keyless entry system may be unable to function could be due to an empty coin battery problems with the receiver module signal interference, a faulty electronic chip. If none of the above are the problem, you can reset the system by disconnecting the 12 voltage battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start system which allows the driver to start the car from a distance and then warm up or cool down the car prior to entering. This feature is extremely helpful particularly during the winter’s cold and chilly months. However, there are times when the remote start system ceases operating due to a range of reasons, such as the battery of a coin that is dead.

A coin-shaped battery that is in the key fob can last for a period of two to four years, based on how often it’s used and the location where it was purchased. The date of use is printed on the packaging or marked in the user manual.

If the key fob stops functioning after being exposed to clean tapwater, take out the battery and clean the electronic chip using a paper towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. In the event of exposure to salty or soapy water, the chip may be fried and you will need to replace the key fob completely.

If you are not sure the battery is defective, you can test its voltage using a multimeter set to the car’s voltage range. Connect it to the terminals for minus and plus. If the voltage is less than 12-13 volts, then you must replace the battery. If you want to, you can try to reset the onboard computer by disconnecting the 12 volt battery for a few minutes, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should begin to run after this.

Faulty Receiver Module

If you don’t see the “Key Detected” message, it could mean that your receiver module is not working properly. It’s the part that transmits an alarm to the car when your key fob is activated, that also acts as an immobiliser. It also stops it from starting until the correct key is present.

This can be due to a number of reasons, such as water damage or just the aging process. If your Peugeot 308 key fob was exposed to dirty tap water, like the chip that is located on the inside will be damaged. In this scenario, you’ll need to take off the battery and thoroughly clean it with isopropyl alcohol or electronic cleaner. When the battery is clean you can attempt to test it again.

If the issue persists the issue persists, it’s a good option to consult an area Peugeot specialist or locksmith. They can utilize the diagnostic tool to identify the issue and fix it.

The loss of your Peugeot keys to your car is an emotional experience. However, a reputable auto locksmith can fix the issue in a matter of minutes. They can cut a new key and program it to your vehicle, making sure you’re ready to get off the road in the shortest time possible. Click here to find a locksmith near you.

Electronic chip that is malfunctioning

The electronic chip in your Peugeot 308 key fob is an crucial component of the remote control system. If the chip is damaged, you may encounter issues starting your car or receive a message stating “anti-theft”. In this situation, the only solution is to replace the key. Professional auto locksmiths can provide this fastest possible time.

The chip inside the chip of your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or any other cause. If your peugeot 3008 key programming key fob has been exposed to dirty or soapy water, it needs to be cleaned right away. You can wipe the electronic component with an absorbent paper towel that has been soaked in isopropyl Alcohol. Then, you need to let the battery completely dry.

Radio interference can cause the key fob to stop functioning. This is usually caused by other devices operate on the same frequency as your Peugeot keyfob. It could be caused by unsafe conditions or objects that are near to the vehicle. If you have this issue it is recommended to visit the Peugeot dealership.

The Peugeot 207/308 Key Fob is delicate and needs special attention. You shouldn’t drop it or throw it around. If you lose something, try to locate it as quickly as you can. You can reset the onboard computer by disconnection of the battery for a few minutes. Disconnect the negative cable before the positive.